#CREATE YOUR CRYPTOCURRENCY TICKER INSTALL#
Wait for the install to complete then enter:.The LCD screen should light up but nothing will be displayed. Once you have double and triple checked your connections, solder the jumper cables to you Raspberry Pi.Pi Pins->LCD Pins GPIO 8 -> SDA GPIO 9 -> SCL 5.0 VDC (either output) ->VCC Ground (any output) -> GND Attach jumper cables using the following (Raspberry Pi Zero W pin out ):.Shutdown and unplug your Pi (wait for the activity LED to stop flashing before unplugging).
Choose "Yes" then exit the configuration menu.Select "I2C Enable/Disable automatic loading" ( link).Find and select "Advanced Settings" from the menu ( link).Open the Raspberry Pi terminal ( link) and type the following commands: sudo raspi-config Give that article a read if you get lost: link Enable I2C Much of the info for this section was pulled from an article posted on, including extra code to make your text do fun things.